Need help?Do you have a question about the Eaton i-on50EX and is the answer not in the manual?
General| Users | 50 |
|---|---|
| Event Log | 1000 events |
| Partitions | 4 |
| Communication | PSTN, Ethernet, GPRS |
| Outputs | 4 |
| Power Supply | 230VAC |
| Operating Temperature | -10°C to 55°C |
| Humidity | 0% to 93% non-condensing |
| Zones | 50 zones |
Describes methods for programming the control unit via keypad or PC.
Crucial information on calculating system power requirements and battery standby times.
Guidelines for selecting and installing appropriate cabling for the system bus.
Detailed steps for mounting the control unit enclosure securely and correctly.
Instructions for fitting the tamper bracket and switch for security compliance.
Guidance on routing the system's bus cable from the control unit.
Procedures for installing and wiring various keypad models.
Procedures for installing and connecting wired and radio expander units.
Critical safety and procedural steps for connecting the control unit to the mains power supply.
Guidelines for routing mains power cables to avoid interference.
Specifics on connecting the mains power using appropriate devices.
Detailed instructions for wiring various types of detectors to the system zones.
Wiring diagrams for four-wire closed circuit detectors.
Wiring configurations for two-wire closed circuit detectors.
How to wire detectors using Fully Supervised Loop (FSL) connections.
Instructions for connecting external devices to the control unit's wired outputs.
Details on the three wired output connectors on the control unit PCB.
Steps for connecting the built-in communicator for alarm reporting.
How to connect external plug-in communicator modules.
Crucial steps for installing the standby battery, including safety precautions.
Steps for powering up the system for the first time and initial configuration.
Menu section for managing detectors and bus devices.
Menu section for setting system arming options and parameters.
Menu section for configuring system-wide options like zone types and defaults.
Menu section for configuring communication settings and reports.
Menu section for performing system tests like walk tests and signal strength checks.
Correct procedures for removing or replacing keypads without system errors.
Overview of product specifications, dimensions, and weight.
Maximum limits for zones, outputs, devices, and other system resources.
Technical details regarding power requirements and supply capacities.
Compliance ratings according to EN50131-6 for security and standby time.
Information on the system's compliance with EMC standards.
Specifications for the panel's and expander's output capabilities.
Compliance with electrical safety standards.
Lists compatible HUDs, detectors, sounders, keypads, fobs, and communicators.
To Next Page
