i-on50EX/EXD Installation
Page 35
7 VIEW LOG
All Events
Mandatory Events
Non-Mandatory Events
8 ABOUT
Panel
Expanders
Keypads
Comms
Module:
19
Panel PSTN (EXD
version only)
Panel Ethernet
Zone Mapping
1
Appears only when device learned in.
2
Appears only in a Partitioned system.
3
Appears only in a Level Setting system.
4
Appears only if Exit Mode is “Final Door Set”, “Lock Set” or “Exit Terminate”.
5
Appears only if Exit Mode is “Timed Set” or “Silent Set”.
6
Appears only when System Options – Confirmation – Confirmation Mode is “Basic”.
7
Appears only when System Options – Confirmation – Confirmation Mode is “DD243” or “BS8243”.
8
Appears only when System Options – Confirmation – Confirmation Mode is “BS8243”.
9
Appears only when System Options – Masking is “On”.
10
Appears only on an EUR variant.
11
Appears here only in a part setting system.
12
In i-on50EX appears only when communications module fitted.
13
Options visible depend on communications module fitted or, for certain options, if using i-on50EXD see
Table 2.
14
Appears only when Report Type=Fast Format
15
Appears when Report Type=CID or SIA
16
Appears only when Static Test call disabled.
17
Appears only when Dynamic Test call is disabled.
18
Appears only when Report Type = Fast Format and Confirmation Mode = Basic.
19
Shows “None” on i-on50EXD if no module fitted.
20
Must be activated by a Eaton’s Security Business External Support Manager.
21
Appears only for KEY-KPZ01 keypads
22
Appears for KEY-K01, KEY-KP01 and KEY-KPZ01.
23
Appears for KEY-KP01 and KEY-KPZ01.
Table 2. Menu Options Available with Communications Modules