Eaton Lumark Caretaker - User Manual

INS #
Brand Logo
reversed out of
black
INS #
IB50 0013EN
Lumark
Installation Instructions – Caretaker
Instructions d’installation – Caretaker
Instrucciones de instalación – Caretaker
Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this
product must be performed by a qualified electrician. This product must be installed in accordance
with the applicable installation code by a person familiar with the construction and operation of the
product and hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting
any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Refer to product label for specific minimum supply conductor requirements.
Risk of Burn- Disconnect power and allow fixture to cool before handling or servicing.
Risk of Personal Injury- Fixture may become damaged and/or unstable if not installed properly.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.
WARNING
DISCLAIMER OF LIABILITY: Eaton assumes no liability for damages or losses of any kind that may arise from the
improper, careless, or negligent installation, handling or use of this product.
NOTICE: Green ground wire provided in proper location. Do not relocate.
ATTENTION Receiving Department: Note actual fixture description of any shortage or noticeable damage on
delivery receipt. File claim for common carrier (LTL) directly with carrier. Claims for concealed damage must be
filed within 15 days of delivery. All damaged material, complete with original packing must be retained.
Safety: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
APPLICATIONS: This lighting fixture is designed for outdoor lighting services, and should not be used in area
of limited ventilation or inside high ambient temperature enclosures. It must be stored in a dry location prior to
installation. Do not expose lighting fixture to rain, dust or other environmental conditions prior to installation
and insertion of photo control or shorting cap (if so equipped). Best results will be obtained if installed and
maintained according to the following recommendations.

Summary

General Safety Warnings

Critical Safety Risks

Covers risks of fire, shock, cuts, burns, and personal injury during installation and maintenance.

Disclaimer of Liability

Eaton assumes no liability for damages from improper product installation, handling, or use.

Important Notices and Guidelines

Includes ground wire, receiving department notes, wiring safety, and application guidelines.

Wall;Pole Mount Installation

Tools and Preparation

Lists required tools and steps for determining mounting surface and pre-drilling.

Mounting Procedure

Details attaching the bracket to the surface and securing the fixture.

Wire Shield Installation

Instructions for installing the wire shield and connecting conduit.

Pipe Mount Installation

Tools and Bracket Attachment

Specifies tools and process for attaching the pipe clamp bracket to the fixture.

Securing Fixture to Pipe

Details tightening mounting bolts after pulling supply wires through the pipe.

Electrical Wiring and Photocontrol

Wiring Connections

Instructions for opening the fixture, making wire connections, and securing wires.

Photocontrol Installation

Guide for rotating the receptacle and inserting the photocontrol or shorting cap.

Warranty Information

Limitation of Liability

Provides information and terms for warranties and limitations of liability.

Eaton Lumark Caretaker Specifications