5
EATON CORPORATION www.eaton.com
Instructions for Undervoltage Release, Shunt Trip, and Overcurrent
Trip Switch
Instructional Leaflet IL0131087EN
Effective January 2019
Figure 11. Step 5 (RF Frame Shown).
Step 6: Route the two secondary leads behind the first molded tab,
down under a second molded tab, and out the end of the accessory
tray.
Figure 12. Step 6 (NF Frame Shown).
Figure 13. Step 6 (RF Frame Shown).
Step 7: If there is another UVR or ST to install in the other available
space of the left accessory tray, install it by repeating Steps 4 and 5.
Step 8: Carefully route the secondary leads of the second installed
accessory by following the same routing path and using the same
molded tabs as the first installed accessory from Step 6.
Figure 14. Step 8 (NF Frame Shown).
Figure 15. Step 8 (RF Frame Shown).
Step 9: The left accessory tray should look as shown in Figure 15 with
two accessories installed and secondary wires properly routed.
Step 10: Place the left accessory tray with the installed UVR and/
or ST accessories back in its original position. Be careful not to bind
secondary wires or connector plugs.
Figure 16. Step 10 (NF Frame Shown).
ST
ST
Molded Tab 1
Molded Tab 1
Accessory Locking Tab
Molded Tab 2
Molded Tab 2
ST
UVR
ST
UVR
ST
UVR
To Next Page
Loading...
