Eaton TRSM0020 - Page 130

Transmission appearance may differ, procedure is the same.
5
Auxiliary Section
Range Cylinder Assembly
How to Assemble the Range Cylinder Assembly
Special Instructions
Apply Eaton Rust Preventative #71213 to the cylinder
walls, cylinder bottom, and the yoke bar. A film should
completely cover the surfaces.
Apply Eaton Lubricant #71214 or equivalent to the O-
rings.
Apply Eaton lockwire #1819 or equivalent to the
actuator capscrews. The wire should anchor the
capscrew at least 2 complete 360° turns. The lockwire
ends should be trimmed and bent out of the way of any
part interference.
Special Tools
Typical service tools needed
To Assemble
1. Inspect the range cylinder O-rings, replace if
damaged.
2. From the range cylinder housing front, insert the
yoke bar.
3. Install the range piston and nut. Finger tighten.
4. Position a new gasket on the range cylinder
housing mounting surface.
5. Install the range cylinder housing and sliding
clutch.
6. Install the actuating bracket and capscrews.
Tighten the capscrews to 50-65 Lb
f
·ft of torque.
Wire securely.
7. Tighten the range piston nut to 70-85 Lb
f
·ft of
torque.
8. Install the cylinder cover capscrews. Tighten the
capscrews to 35-45 Lb
f
·ft of torque.
2
A/06-4
H/29-6
H/28-9
H/29-4
H/29-7
H/29-3
H/29-5
5
3
7
8
1
4
6