Eaton TRSM0020 - Page 54

Transmission appearance may differ, procedure is the same.
13
External Parts
Air System
How to Install a Slave Valve
Special Instructions
Make sure gasket mounting areas are clean.
Special Tools
Typical service mechanic tools needed
To Install
1. If previously removed, install new insert valves.
Tighten to 20-25 Lb
f
·ft of torque.
2. Position the corresponding new gasket on the
slave valve mounting surface.
3. Position the slave valve over the gasket.
4. Apply Eaton/Fuller Sealant #71205 or equivalent
to the retaining capscrews.
5. Install the retaining capscrews. Tighten to 8-12
Lb
f
·ft of torque.
Final Check
Make sure the retaining capscrews are properly
torqued.
H/49-6
H/49-5
H/49-4
2
3
4, 5
Range Valve
4
1
1