Gear Engagement
1. Turn the ignition key to “ON” and allow the system to power-up.
Note: Engine cranking is delayed until the transmission power-up is
complete
and the
gear display shows a solid “N”.
2. Start the engine.
3. Apply service brake.
Note: If the service brake is not applied while selecting a starting gear,
the initial
start
gear will not engage, requiring the driver to select Neutral and apply
the
brak
e while selecting the desired mode.
4. Select the desired mode and starting gear on the shift console.
Note: The transmission overrides inappropriate start gear s
elections to avoid
driv
eline damage.
5. Release vehicle parking brake.
6. Release service brake and apply accelerator.
Important: If the driver presses and holds both
pedals (even if done
accidenta
lly), the launch will be abrupt, and the engine and brake forces
may
rock
and bounce the vehicle, which could damage the driveline. Releasing ei
ther
pedal will stop th
is immediately
SERVICE
SHIFT
MANUAL
EATON FULLER
TRANSMISSIONS
LOW
D
N
R
Reverse
Neutral
Drive
Manual
Low
- Upshift
- Downshift
Button not used
Service Indicator
Driver Instructions Quick Reference Guide
Eaton UltraShift PLUS Transmissions
TRDR0941 EN-US
January 2014
Important: This is a quick reference guide
only. See Driver Instructions TRDR1110
for complete operating instructions.
!
4
© 2013 Eaton Corporation. All rights reserved
1/28/14
Features, Continued
Engine Over-speed Protection:
The transmission system upshifts if necessary to prevent engine overspeed in Drive,
MANUAL and LOW modes.
Shuttle Shifting:
Shuttle shifting from Reverse to any forward mode is only allowed if vehicle speed is at or
near zero.
Skip Shifting:
When appropriate, the system may skip shift in Drive mode.
Auto Neutral:
• The system will automatically shift into Neutral if the vehicle is left in Drive
and
the parking brake is set.
•
“AN” will appear in the gear display. Driver must select Neutral and
then select
the desired for
ward or reverse mode with the service brake applied.
ABS/ATC Interaction:
See Driver Instructions manual TRDR1110 for detailed information.
Creep Mode Operation:
The transmission system will maintain the current gear and operate at idle.
1. Select MANUAL or LOW mode. (Default setting for Drive is disabled.)
2. Apply throttle until you feel the clutch engage, then slowly release throttle pedal.
3. Remove foot from throttle and allow the vehicle to idle in gear.
4. To exit Creep mode, apply the throttle or press the service brake.
Trailer Connecting
• Prior to backing under the trailer, ensure proper trailer height.
Use Low mode
(1st
gear) for forward direction and Reverse (R1) for reverse direction.
To Next Page
Need help?
General
