124
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Eaton Push Button Shift Control Device (PBSC) | Removal and Installation TRSM0940
Eaton PBSC Removal
1. Using a 1/4” socket, loosen the retaining bolt and dis-
connect the 30-way connector from the back of the
Shift Control.
2. Using a 11/32” wrench, remove the 2 nuts and lock
washers from the back of the Shift Control and remove
the Shift Control.
Note: Shift Control location and use varies with each
truck.
Eaton PBSC Installation
1. Install the Shift Control in the mounting location. Then,
using a 11/32” wrench, install the 2 lock washers and
nuts and tighten to 14–16 lb-in (18–21 N•m).
2. Using a 1/4” wrench, reconnect the 30-way connector
to the back of the Shift Control and tighten to 10 +/- 3
lb-in (13.5 +/- 4 N•m)
To Next Page
Loading...
