214
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Main Case Main Shaft without Low Force Gearing Disassembly | Disassembly and Assembly TRSM0940
Main Case Main Shaft Disassembly
1. Remove the front (4th and 5th Gear) Sliding Clutch
from the Main Shaft
2. From the rear of the Main Shaft, remove the key from
the Main Shaft keyway.
Note: When removing no-burn washers or spacers,
note their location on the Main Shaft to facilitate reas-
sembly. Keep each washer with the corresponding gear
it was mated against.
3. Remove the rear spacer from the Main Shaft.
4. Remove the Reverse Gear from the Main Shaft.
To Next Page
Loading...
