EBA 435 E - Page 23

- 23 -
Eject function
If the
z
button is kept pressed the
backgauge
I
will advance to measurement
9 cm (standard setting of the machine).
Finally the backgauge moves to the last
setting.
If the
z
button is released while the
backgauge moves to the front, the backgauge
stops and moves to the last setting.
Cutting activation
Warning!
•
Run backgauge to the front for turning the
paper stack.
•
Do not interrupt the upward movement of the
blade by performing switching procedures.
•
Release blade only when LED "S" has gone
out. ( Only EBA 435 EP).
•
Close the front safety guard
A.
•
Blade must always be at the top and be
covered by the clamp. Do not touch the blade
- risk of injury! (see security information on
page 35).
•
Operation
•