EBA 435 E - Page 28

- 28 -
EBA 435 E • EBA 435 EP
Turn the blade depth adjustment screw to the
left until it stops (screwdriver found in
tool set (A).
•
Blade and cutting stick replacement
•
Cutting stick replacement :
•
Lift the cutting stick by hand and pull it out.(1.).
•
If needed the cutting stick can be turned or
exchanged. (The cutting stick can be used
eight times). (2.).
Waring! The machine may only be
operated when the cutting sticks are
inserted!
After exchanging the cutting stick close the
clamp by moving the clamp lever to the left
(3).