EBA 551-06 - Cut Cannot Be Made Issues; Hydraulic System Malfunctions

- 39 -
B
A
•
Possible malfuntions
•
• Oil pressure set too low. © Increase oil
pressure at rotary control (A).
• Hydraulic oil shortage. © Check hydraulic
oil level (B), if necessary, top up.
"CUT" appears on the display,
• the clamp is not in upper position.
© Operate the foot pedal (clamping) again.
CUT cannot be made
• Measurement has not been reached
correctly. LED "S" does not turn off.
© Push the
S
button again.