11
Check the end of each
inlet hose to ensure the
black rubber seal is fitted.
Connect the L-shaped
inlet hose ends to the
back of the machine.
Tighten by hand by turning
clockwise. Ensure the
hoses are not twisted or
kinked before connecting
the other straight end of
the hoses.
Connect the straight end
of the inlet hoses to the
appropriate water supply
isolating valve. When
complete, open isolating
valves to let water into the
machine.
Check all connections for
no leaks.
1. 2. 3.
Dual fill machines
• The hot water supply is always located on the right-hand side connector
marked red.
• Dual fill machines can operate with cold supply only but in these cases a Y
connecting piece (not supplied) must be used and connected to the cold
water supply isolating valve. From this, both the hot and cold water inlet
hoses can be connected to the two inlet connections at the rear of the
machine.
• Always ensure the hot and cold water supply is connected to the correct
hot and cold water intake at the rear of the machine.
Getting started
Water connection (continued)
To Next Page
Loading...
Need help?
General
