12
5
Drainage connection
Option 1 - Washing machine trap with standpipe
1. Unclip the drain hose from the back of the machine.
2. Push the drain hose down into in the drainpipe.
3. Attach the drain hose guide accessory and secure the drain hose
from any movement.
This appliance must be connected in compliance with any local or national
regulations or byelaws.
The drainpipe should always be vertical and not horizontal.
6
Electrical connection
You will find your plug and mains lead plugged into the back of
your washing machine. Gently pull the plug free and close the
space with the cap attached. The mains lead is 1.5m. Plug the mains
lead into an AC220-240v/50Hz approved socket.
• Do not use an extension cord or double adapter.
• The appliance should be positioned so that the electrical supply can be
easily accessed to be switched on and o.
• Do not modify the supplied electric mains cable. If the cable is not long
enough then reposition the washing machine or move the electrical socket.
• A professionally qualified electrician can move the socket and it should be
in line with local or national regulations or byelaws.
Option 2 - Direct into the undersink appliance trap
1. Unclip the drain hose from the back of the machine.
2. Ensure the appliance trap nozzle is open and unblocked at the sink.
3. Place the drain hose over the appliance trap nozzle and secure tightly with
a hose retainer clip.
Getting started
To Next Page
Loading...
Need help?
General
