7
1
2
• Release and li the ends of
both straps.
• Pull both straps away from each
other, through the loop, to tighten.
• Press down to reattach the ends
of both straps.
Set up and use
Charge before use
a) Plug the Power Adapter into the charging port at the top
of the PowerWand.
b) It will take approximately 3-4 hours to reach a full charge,
indicated by 4 green LEDs on the side of the PowerWand.
Note: CoolDri Versa can be used while it is charging.
However, for enhanced ease of use, we encourage you to
charge it before each nightly use.
Putting on the headband
a) Place the product on a surface. Adjust the headband so
that it stays on your head.
To Next Page