EasyManua.ls Logo

Eberg AIRO 85 - Safety Conditions

Eberg AIRO 85
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AIRO 85EN
9
www.eberg.eu
Installation must only be carried out by qualifed persons.
Make sure that the installation complies with each countrys current mechanical and
electrical norms.
Extreme caution is necessary when the fan is used by or near children or Invalids and
whenever the fan is left operating unattended.
Avoid using extension cord as the extension cord may overheat and cause a risk of re.
The Main Power Switch and the On/Of switch should not be used as the sole means of
disconnecting power.
Always unplug the power cord before servicing or moving the unit.
Do not pull the power cord to disconnect with power source. Always grasp the plug to pull
out.
If the supply cord is damaged, it must be replaced by the manufacturer or it’s service agent
or a similarity qualifed person in order to avoid a hazard.
Do not insert any objects into the fan as it may cause an electric shock or injure or damage
to the fan.
Do not block or tamper with the fan in any manner while it is in operation.
Do not leave the fan unattended.
Always unplug fan when not in use.
This fan is not intended for use in wet or damp locations.
Never locate a fan where it may fall into a bathtub or other water container.
Do not use the fan outdoors.
Disconnect the fan from the mains power when not in use, and before servicing or
performing any maintenance.
Always disconnect the fan from the power supply when moving it from one location to
another.
Keep the fan clean and maintain in good condition.
Set the device up in vertical and stable position.
Ensure that inlet and outlet are not obstructed.
Make sure that there are any loose items, or parts of the packaging close to the operating
unit.
Appliance should not be operated in unmounted or incomplete condition.
When not in use store in a safe, dry, childproof location.
Ensure that the equipment is not to close to heat emitting appliances or placed in direct
sunlight.
Do not expose to water splashes, do not immerse.
This device must not be used in explosive or corrosive atmospheres.
This appliance is not intended for use by young children or inrm persons unless they
have been adequately supervised by a responsible person to ensure that they can use the
appliance safely. Young children should be supervised to ensure that they do not play with
the appliance.
1. SAFETY CONDITIONS

Related product manuals