M3G084 / M3G112 Disassembly instructions
Document no.: - • Change: 01 • Release date: 2019-02-12 • (VM-POK) • Page 3/7
ebm-papst Mulfingen GmbH & Co. KG • Bachmühle 2 • 74673 Mulfingen • Germany
Phone +49 7938 81-0 • Fax +49 7938 81-110 • info1@de.ebmpapst.com • www.ebmpapst.com
6. Only applies to type with plastic terminal box.
a. Unfasten the four screws at the plastic terminal box and detach the
b. Unfasten the four screws in the plastic terminal box and detach the
7. Only applies to type with connector block.
a. Unfasten the two screws on the back of the connector block and
8. Use a screwdriver to prise out the circuit board.
9. Completely remove the circuit board.
To Next Page
Loading...