Warning: Failure to recharge the battery at least once a month may
result in a battery that will no longer hold a charge.
SAFETY REMINDERS
PRE-RIDE CHECKLIST
Loose Parts
Check and secure all fasteners before every ride. You should make sure
that the handlebar riser clamp bolts are adequately tightened. There
should be no unusual rattles or sounds from loose parts or broken
components. If you are not sure, ask an experienced mechanic to check
the bike over for you.
Brakes
Check the brakes for proper function. When you squeeze the lever, the
brake should provide positive braking action and lock up the wheel while
stationary.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are
rare, it is possible for an aggressive rider to cause damage to their frame
from a cash or hard impact. Get in the habit of inspecting yours regularly
to avoid accidents.
Tyre Ination
Periodically inspect the tyres for excess wear, regularly check the tyre
pressure and re-inate as necessary. If you get a at tyre, the inner tube
can be patched or a new tube can be purchased from an EBOX
authorised dealer.
Safety Gear
Always wear proper protective equipment such as an approved
safety helmet, elbow and knee pads. Always wear motorcycle boots,
never ride barefoot or in sandals. Keep and loose objects away from the
wheels, motor and the drive system.
Starting The Bike
Always take care when starting the bike as it is very powerful, with
adjustable motor response and speed limiter. Always check these
settings before starting the bike.
Note: Make sure the power
is turned OFF when unit is
not in use. If the
power switch is left on for
an extended period of time,
the battery may reach a
stage at which it will no
longer hold a charge.
Plug the charger into a wall
outlet. If the lights on the
charger do not light up,
check the power to the
outlet. If necessary, try a
dierent outlet.
Turn the power OFF before
charging. Plug the
charger into the charger port
to charge your EBOX. Then
turn the power back ON.