BEFORE YOU BEGIN
Open the box and inspect the contents
for any scratches, dents or cable kinks
that may have occurred during shipping.
Your EBOX was 85 percent assembled
and packed at the factory, so there
should not be any problems, even if your
box has a few scratches or dents from
shipping.
However, if you do nd an issue, please
report it immediately via our contact
form which can be reached here:
Http://www.stomp-group.com
Remove the bike and place on a suitable assembly stand, ensuring the
bike is secure and will not tip over.
Remove all protective packaging taking care not to cut any cables or
components if using a sharp blade. DO NOT remove the graphics’
protective lm until the bike is fully assembled to avoid any accidental
damage. DO NOT cut the zip ties that group the control cables together.
Remove all loose items such as the front wheel, number board, front
mud guard and accessory box.
Check that all components are present and nothing appears to have
been damaged or missing from transit.
Place these items in a safe place to avoid any accidental damage.
Discard all packaging along with the cardboard box via the appropriate
recycling stations.
You are now ready to begin assembling your bike.
MAKE SURE THE KEY SWITCH IS TURNED “OFF”.
Estimated Assembly and Set-Up Time
We recommend assembly by an adult with experience in motorbike
mechanics.
• Allow up to 30-40 minutes for assembly.
• Allow up to 1 hour to conduct a full PDI after assembly (PDI
instruction can be found at the back of this manual).
• Allow up to 7-9 hours for initial charge depending on the model.
To Next Page
Loading...