Front Wheel
1. Undo the retaining nut and remove the
axle from the forks. Be careful not to lose
either of the wheel washers.
2. Place the wheel between the forks
ensuring that the disc is situated between
the brake calliper pads.
3. Insert the axle through the left fork
dropout.
4. Slide the longer 28mm spacer onto the
axle between the wheel (disc side) and fork
leg.
5. Continue sliding the axle through the
wheel and right fork leg, making sure to
install the second shorter (24mm) spacer.
5. Secure the axle in place using the
nut we previously removed and tighten to
47Nm.
1.Start by removing the brace that
has been tted between the 2 shock
mounts to protect your Ebox during
shipping.
Rear Shock Absorber
3. Lift the frame allowing the shock
and swingarm to pivot. Align the lower
mounting hole with the corresponding
mount point on the swing arm.
2. Install the shock into the upper shock
mounting position. There are 2 upper
shock mounting points. Mounting in
either position A or B will eect the seat
height of your Ebox.
Secure the shock in the mounting point
and tighten down to 27Nm.
Then, using the bolt we
previously removed, secure the
number board to the fork
mounting tab and tighten down
securely. Keep the control cable
behind the number board to
secure them into position.
4. Use the bolt to secure the shock to
the swing arm mount and tighten the
nut to 27Nm using a wrench.
To Next Page
Loading...