AVA PRO - Assembly instructions for the CPX300W alarm control panel 5 / 23
2. GENERAL INFORMATION
CPX300W is a simple alarm control panel, which can be extended by 4 additional modules, allowing a
significant extension of functionality. Thanks to this structure, the user can individually choose
equipment and create a system that fully satisfies his needs and expectations.
A well-thought-out arrangement of components and an intuitive dedicated EBS Config 2.0 application
for device programming make the installation quick and pleasant, and the configuration itself is very
simple and trouble-free.
2.1. System properties
1. Available data transmission channels:
Data transmission via the GSM module,
Data transmission via a wired Ethernet network,
Data transmission via a wireless Wi-Fi network.
2. Wireless two-way system components:
KP3W - keypad,
MC-30 - magnetic contact with an additional input,
PIR-30 - motion detector,
PIRC-AM-30 - motion detector with a camera,
RC-30 - remote control,
STAG-30 – touchless user identifier AVA KEY,
BM8000PLx-C3W – visual / audible wireless siren (support from firmware version 3.1.6).
3. Wireless one-way components cooperating with the system.
Installation of the MOD-RF433 module on the CPX300W motherboard allows you to expand the
supported devices by the following list:
MC-10 - magnetic contact,
MC-11 - magnetic contact with an additional input,
PIR-10 - motion detector,
PIR-11 - motion detector (PET),
SD-20 - smoke detector,
FL-10 – water flood detector,
GS-21 - gas detector (carbon monoxide and natural gas),
GS-22 - gas detector (carbon monoxide and propane-butane),
MD-10 - movement detector,
GB-10 - glass break detector.
4. Modules:
MOD-GSM-2G / MOD-GSM-3G (including 2 nano SIM holders) - cellular network
communication module 2G or 3G,
MOD-ETH - wired Ethernet module / MOD-WiFi communication module – wireless Wi-Fi
module,
MOD-RF433– 433 MHz RF communication module,
MOD-ZWAVE - communication module with Smart Home devices.
To Next Page
