EC POWER XRGI 20 - 4. ASSEMBLY; 4.2 Transport and Handling; 4.3 Installation Room; 4.5 Required Minimum Clearances

XRGI® COMMISSIONING INSTRUCTION VERSION 1.0 2019
3
CONTENT
1. SYSTEM AND DOCUMENTATION INFORMATION 3
1.1 VALIDITY OF THE INSTRUCTION 3
1.2 RATING PLATE 3
2. SAFETY INSTRUCTIONS 4
2.1 INFORMATION, SAFETY AND WARNING SYMBOLS 4
2.2 INTENDED USE 4
2.3 GENERAL SAFETY INFORMATION 5
2.3.1 HANDLING COOLANT AND ENGINE OIL 6
2.3.2 ACTIONS WITH SMELL OF GAS IN BUILDINGS 6
2.3.3 ACTIONS WITH FIRE OR INGRESS OF WATER 7
2.3.4 ACTIONS WITH SMELL OF EXHAUST GAS IN BUILDINGS 7
2.3.5 FROST PROTECTION 7
2.3.6 CONTACT HAZARD 7
2.3.7 EXPLOSIVE AND EASILY FLAMMABLE MATERIALS 8
2.3.8 COMBUSTION AIR SUPPLY 8
2.3.9 MODIFICATIONS TO THE XRGI® SYSTEM COMPONENTS 8
2.3.10 FILLING AND TOPUP LIQUID 9
2.3.11 PROPERTY DAMAGE CAUSED BY IMPROPER USE OF AND/OR UNSUITABLE TOOLS 9
2.3.12 MODIFICATIONS IN THE VICINITY OF THE XRGI® SYSTEM 9
2.3.13 OPERATION WITH LIQUID GAS 9
2.3.14 WORKING ON THE ELECTRICAL SYSTEM 10
2.3.15 SAFETY EQUIPMENT ON THE XRGI® SYSTEM 10
2.3.16 SAFETY AND WARNING LABELS ON THE XRGI® SYSTEM 11
2.4 WARRANTY INFORMATION 11
2.5 REGULATIONS, STANDARDS AND LAWS 11
3. COMMISSIONING XRGI® 6 13
3.1 INSTALLATION CHECK 13
3.2 COMMISSIONING 13
3.2.1 BLEEDING 14
3.2.2 ELECTRONICS COMPARTMENT 15
3.2.3 PARAMETER SETTING 16
3.2.4 MAINTENANCE 18
3.2.5 IO STATUS 18
3.2.6 PRODUCTION 18
3.2.7 FLUE GAS MEASUREMENT 19
3.2.8 MODEM CALL 20
3.2.9 COMPLETION 20
4. COMMISSIONING XRGI® 9 21
4.1 INSTALLATION CHECK 21
4.2 COMMISSIONING 21
4.2.1 BLEEDING 22
4.2.2 ELECTRONICS COMPARTMENT 23
4.2.3 PARAMETER SETTING 24
4.2.4 MAINTENANCE 26
4.2.5 IO STATUS 26
4.2.6 PRODUCTION 26
4.2.7 FLUE GAS MEASUREMENT 27
4.2.8 MODEM CALL 28
4.2.9 COMPLETION 28