2
4. Antenna
Make sure to install the GSM antenna as high as possible and do not fold the excessive wire of the
antenna.
5. Power
The unit can operate with voltage between 12V to 24V AC or DC by the Orange and Yellow wires of
the unit. If DC power is used, the yellow wire is the Negative and the Orange wire is the Positive.
Wait 25 seconds for the unit to set up after connecting the power. The GSM and Status LEDs will
start to flash when the system is ready.
6. Memory
The unit can be programmed with 1000 phone numbers to become as authorized users. The system
will respond or answer (according to the settings – see below) to the call of authorized users only and
hang-up on unauthorized calls.
7. Output
The Grey and Purple wires of the unit are the internal relay’s output connections COM & N.O. that
can be used to activate any gate, garage door or alarm. Use the Grey (Com.) and the Purple (N.O.)
wires in the unit to trigger the control panel of the appliance.
8. Relay’s Function
You can select one out to two functions for the internal relay to activate the external control panel by:
Dip – Switch # 3 : OFF => Pulse function or ON => Latch function
9. PROGRAMM MODE
In Program Mode you can:
• Add or delete users’ phone numbers.
• Lock and Unlock the system by the MASTER number.
Entering PROGRAM MODE:
1. Set DIP-SWITCH # 1 to ON position to enable entering Program Mode.
2. Dial the unit’s Sim Card phone number from any phone.
After the first ring, the unit will answer the call with a long “Beep” sound and wait for your
programming instructions.
3. First you need to clear the memory of the Sim card from any data and phone numbers.
For DELETING
all the phone numbers in the unit’s memory except the MASTER phone
number;
Press
* + 4 + * + * + * + #
=> a long beep to confirm.
4. Master Phone Number
Program-in the Master Phone Number (MPN) that will enable you to make all the programming
features (from this phone number only) without the need of accessing the unit in the future.
Please Note!
The MPN can enter Program Mode without setting Dipswitch #1 on in the unit. The unit will
always answer the Master phone number and automatically enter programming mode, even if the
Dip Switch No. 1 is OFF.
For programming the MASTER
Phone Number:
Press
000 + * + phone number + #
=> a long beep to confirm.
The unit will announce the phone number after programming to confirm.
To Next Page
Loading...
