ECG EWF 1053 MD - Installation; Shipping Screws Removal; Adjusting Leveling Feet; Power Connection

English English
8
INSTALLATION
Shipping screws removal
1. Before starting the washing machine, remove the
4 shipping screws and rubber washers from the
back of the washing machine. If the screws are not
removed, they can cause strong vibrations, noise
and malfunction of the washing machine and will
void the warranty.
2. Loosen the shipping screws by turning them
counterclockwise with asuitable wrench.
3. Remove the shipping screws by pulling them
straight out.
4. Insert the plastic plugs provided in the accessories
bag into the holes left after removing the screws.
Shipping screws should be stored for future use.
Note:
Remove shipping screws before rst use of
the washing machine. Malfunctions caused
by operating the washing machine with the
installed shipping screws are not covered by the
warranty.
Adjusting the leveling feet / adjusting the adjustable stops
1. Do not install the washing machine on asurface
(e.g. carpet) that would prevent ventilation from
below.
• To ensure quiet, vibration -free operation, install it
on asolid surface.
• You can level the washing machine with the
adjustable feet.
• Loosen the plastic lock nut.
2. If you want to increase the height of the washing
machine, turn the feet clockwise. If you want to
lower the height of the washing machine, turn the feet counterclockwise.
• Once the washing machine is levelled o, tighten the lock nuts by turning them clockwise.
3. Never put underneath the washing machine cardboard, wood or any other similar materials.
• When sweeping and washing the oor on which the washing machine is placed, take care not to disturb
the horizontal position of the washing machine.
Power connection
• The washing machine requires power supply of 220-240 V, 50 Hz.
• The power cable of your washing machine is equipped with agrounded plug. This plug should always be
inserted into a10 Agrounded outlet.
• If you do not have asuitable outlet and agrounded fuse, consult aqualied electrician.
• We are not liable for damages resulting from connecting the appliance to an ungrounded outlet.
Note:
Operating the washing machine at low voltage shortens the service life and reduces its eciency.
Water supply hose
1. Depending on the specications of the washing machine, your washing machine may be connected to
acold water supply or to acold and hot water supply. Ahose with awhite cap should be connected to the
cold water supply and ahose with ared cap to the hot water supply (if available).
XX44
X4
1
3
2
4
1