ECG FS 410 - Cleaning and Maintenance

GBGB
36
In NATURAL mode, the speed change according to the following diagram:
High
Medium
Low
Stop
T = 90 s
High
T = 90 s
High
Medium
Low
Stop
Medium
T = 90 s
High
Medium
Low
Stop
Low
Program SLEEP is acombination of the NATURAL mode and gradual reduction of the fan speed.
1. When you set high speed , the fan will run in the rst 30 minutes in NATURAL mode at high speed. It will
reduce speed after 30 minutes to medium and after next 30 mintes the fan moves to low speed in the
NATURAL mode, where it remains until shuto.
2. When you set medium speed , the fan will run the rst 30 minutes in the NATURAL mode at medium
speed. In the next 30 minutes it switches to low rpm in the NATURAL mode where it remains until shuto.
3. When setting alow speed, the SLEEP mode is the same as the NATURAL mode at low rpm.
Note:
In the NATURAL and SLEEP modes, the speed level will not be signalled by the relevant control light.
Remote controller
You must insert abutton battery (CR2032, 3 V),
which is included in the package, into the remote
controller. Open the cover and insert the battery
into the remote controller, see gure. Keep
proper polarity of the battery. If you will not use
the appliance for along time, remove the battery
from the remote controller.
If the battery is discharged, replace it with anew
one of the same type.
Note:
When using the remote controller, aim it at the sensor located on the device.
If there are obstacles between the remote controller and sensor, the signal transmission might not occur.
CLEANING AND MAINTENANCE
• Before cleaning pull out the plug of the power cord from the outlet!
• Use soft, dry cloth for cleaning. Do not use solvent, thinners or other aggressive solvent containing
cleaners.
• Make sure that no liquid enters the device.
• Protect the appliance from water and high humidity!
PULL
PRESS
Battery Installation