ECG MS 300 - Temperature Monitoring Settings; Device Start and Reset

GB
7
• If the setting is not changed for 8 seconds, the data is saved and the
setting ends.
• Press the "ALARM" button to turn on / o the alarm,
• Alarm sound for 2 minutes, alarm format:
• 0-10 s: one beep/second
• 10-20 s: two beeps/second
• 20-30 s: four beeps/second
• 30 s later: continuous beeping
• When the alarm sounds, press the "SNZ" button, the alarm will move
ahead by 5 minutes, press another button to end the alarm.
Temperature monitoring settings
• Hold down the "UP" button for 2 seconds to enter the ALERT setting
mode.
• Setting order: upper limit, lower limit, ON / OFF, exit
• When setting limits, press the “CH” button to assign dierent channels.
• The default value of the upper limit is + 70 ° C and the lower limit is -50
° C.
• During setting, the value ashes at a frequency of 1 Hz.
• Press the "MODE" button to conrm the setting and move to the next
item.
• Pressing the "UP" button changes the setting one step up, holding for
more than 2 seconds changes the setting by 8 steps every second.
• Pressing the "DOWN" button changes the setting one step up, holding
for more than 2 seconds changes the setting by 8 steps every second.
• If the setting is not changed for 8 seconds, the setting is terminated.
Start & reset
• During start-up or reset, the LCD display and illumination light up fully
for 3 s, a beep sounds and the device goes into standby; the temperature
and humidity test takes place, after 3 minutes the RF signal from the
sensors is received, the auto RCC signal and the device terminates the
connection for 7 minutes.
• Default alarm: 0:00
• Default weather icon: partly cloudy
• Default temperature: °C
• Default clock format: 24H