ECG MS 300 - Time Setting Mode; Setting the Alarm

GB
6
• Hold the "DOWN" button for more than 2 seconds to open the RCC
reception model.
• Press the "CH" button to select the RF channel, CH1> CH2> CH3> CH1
will be displayed.
• Hold the "CH" button for more than 2 seconds to re-enter the current
channel.
• With the ALARM on, press "SNZ" to enter sleep mode; the alarm restarts
5 minutes later.
Time setting mode
• In clock mode, hold down the "MODE" button for more than 2 seconds
to enter the setting mode.
• The set item ashes at a frequency of 1 Hz.
• Setting: year  month  day  language  hour  minute  time
zone  end. Exit the setting mode after setting.
• Press the "MODE" button to conrm the setting.
• Pressing the "UP" button changes the setting one step up, holding for
more than 2 seconds changes the setting by 8 steps every second.
• Pressing the "DOWN" button changes the setting one step down,
holding for more than 2 seconds changes the setting by 8 steps every
second.
• The display of the moon phase and week changes according to the year,
month and day.
• If the setting is not changed for 8 seconds, the data is saved and the
setting ends.
Setting alarm
• Hold the "ALARM" button for more than 2 seconds to open the alarm
mode.
• The set item ashes at a frequency of 1 Hz.
• Setting: hours  minutes  end
• Pressing the "UP" button changes the setting one step up, holding for
more than 2 seconds changes the setting by 8 steps every second.
• Pressing the "DOWN" button changes the setting one step down,
holding for more than 2 seconds changes the setting by 8 steps every
second.
• Press the "ALARM" button to conrm the setting.