10
CS-345
CS-300
CS-340
A
A
B
C
Securely hold the saw.
OPERATION
WHEN THE ENGINE IS COLD
WARNING DANGER
Make sure bar and chain are not touching anything when
starting the saw.
• Move chain brake lever fully forward to engage chain brake
before starting.
• Fill the fuel tank with fuel.
• Fill the chain oil tank with lubricant.
• Turn switch (A) to “RUN” position (I).
• Pull choke (B) all the way out (closed position).
• Push purge bulb (C) 10 times.
• Pull starter handle several times until first firing sound is
heard. (Secure unit on ground with your knee or foot.) (5 - 6
pulls maximum.)
• Push choke (B) all the way in. (open position)
• Pull starter handle again.
NOTE
If engine does not start after 5 pulls, repeat instructions.
WHEN ENGINE IS HARD TO START
WARNING DANGER
Clutch engages and chain may rotate when engine is started
with throttle control latch engaged. Never use the throttle
control latch for cutting. Use only when starting the
engine.
• Press throttle control lockout down, squeeze throttle trigger,
and push in throttle control latch.
• Pull starter handle.
• When engine starts, immediately squeeze throttle trigger to
release the latch otherwise damage to clutch may result.
NOTE
Do not pull starter rope out to the maximum possible
position.
Do not allow recoil handle to snap back against the
casing.
To Next Page
Loading...
Need help?
General