19
1/5
WARNING DANGER
Use of replacement saw chain and/or guide bar other than that specified, or operation without the “tip guard” in place, may
cause severe kickback resulting in serious injury.
Only use saw chain designated as, “LOW-KICKBACK,” that meets the ANSI B175.1-2000 Standard, and the Echo guide
bar specified.
CHAIN AND GUIDE BAR COMBINATIONS
*Reduced nose radius symmetrical bars (OREGON name — Double Guard)
SETTING THE SAW CHAIN
For setting saw chains, round file (4 mmø: 5/32”) and flat file are used.
• To keep correct position and correct angle, use the file holder.
- Round file and flat file are available from your Echo Dealer.
• File cutters as below.
Type : 91VG
HOLD FILE HOLDER
LEVEL
Depth
gauge
ONE FIFTH OF FILE DIAMETER
REMAINS ABOVE CUTTER EDGE
To sharpen other type chain, follow chain manufacturer’s instructions
30°
PUSH FILE AS SHOWN
Keep this angle
IMPORTANT
Chain and guide bar gauge size must be identical. Use Bar/Chain combinations shown in table
above.
IMPORTANT
If your kick guard is damaged or lost, contact your Echo dealer for a replacement. For the
name of the Echo dealer nearest you, Call: 1-800-432-ECHO (3246) or on the web at
www.echo-usa.com.
Refer to your Chain Saw Safety Manual for kick guard application information.
The following combinations may be used on CS-300, CS-340 or CS-345.
LEDOM
RAB
HTGNEL
ELBUOD
RABDRAUG
NIAHCWAS
KCIK
DRAUG
N/POHCE
)N/PMEO(
OHCE
.ONTRAP
SKNILEPYTHCTIPEGUAG
N/POHCE
)N/PMEO
(
003-SC
043-SC
543-SC
"21
"41
"61
znetnI"21
MT
znetnI"41
MT
"61znetnI
MT
105473021
102573041
107573061
105473221
102573241
107573261
540719
250719
750719
540719
250719
750719
54
25
75
54
25
75
GV19"8/3050.
1094982
94982
To Next Page
Loading...
Need help?
General