6
When controlling 2 systems, the controller will receive all status updates on the currently selected
vehicle and will receive only trigger alerts for the 2nd vehicle. Use these steps to change vehicles:
SELECTING CAR #1 OR CAR #2
Vehicle #1: Press the “P” and “LOCK” buttons for 1 second to select Car #1. The controller will beep/
vibrate once and the clock will change to “CAR 1”.
Vehicle #2: Press the “P” and “UNLOCK” buttons for 1 second to select Car #2. The controller
will beep/vibrate twice and the clock will change to “CAR 2”.
Multi-Car Operation
The controller has 2 convenient timer functions. The PARKING TIMER tells you how long you’ve
been parked in case you are at a parking meter or other parking areas with time restrictions. The
REMOTE START TIMER tells you how long your engine has been running in remote start mode.
PARKING TIMER: Press LOCK twice within 5 seconds. When the controller receives both LOCK
conrmations, it will start the timer indication by the clock changing to “00:00 P”.
REMOTE START TIMER: This turns on every time you remote start. indicated by the clock changing
to “00:00RS”.
Note: Pressing the “P” during either timer mode will switch between the timer and clock.
PARKING TIMER & REMOTE START TIMER
SELECTING MELODY & VIBRATE MODES
Whenever 2-way alerts are received from the system, the controller can alert you with a melody,
vibration, or both. By default, the controller is set for melody only. Press the “P” and “TRUNK“
buttons simultaneously for 1 second to change the setting. The melody & vibrate icons
on the status screen will turn on & off indicating your selection.
Controller Options
To Next Page
Loading...