17
SHRED 'N' VAC
®
OPERATOR'S MANUAL
AIR FILTER
Level 1.
Tools required: 25-50 mm (1-2 in.) cleaning brush.
Parts required: 90008 REPOWER
TM
Air and Filter Kit
NOTE
Clean daily.
1. Close choke (Cold Start Position [ ]). This prevents dirt from
entering the carburetor throat when the air filter is removed.
Brush accumulated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and inspect the element for
damage. If element is fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be certain
• still fits the cavity in the air cleaner cover.
• is installed with the original side out.
FUEL FILTER
Level 1.
Tools required: 200-250 mm (8-10 in.) length of wire with one end
bent into a hook. clean rag, funnel, and an approved
fuel container.
Parts required: 90008 REPOWER
TM
Air and Filter Kit
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing, or
handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
To Next Page
Loading...
Need help?
General