To Next PageTo Next PageWhy does my Echo ES-250 SHRED ‘N’ VAC Blower run but not vacuum properly?
If your Echo Blower runs but doesn’t vacuum well, the elbow or debris bag might be clogged. Check and clear them as needed, ensuring the bag isn't folded over at the intake during use. Also, obstructions in the vacuum tube could be the reason. Inspect the vacuum tube and remove any blockages. Avoid vacuuming wet leaves.
What to do if my Echo ES-250 SHRED ‘N’ VAC jams repeatedly?
If your Echo Blower jams repeatedly during use, it's likely that the material you're vacuuming is too big or too hard for the blades to shred. Use the vacuum for leaves and small twigs, with a maximum size of 1/4” diameter x 3” long.
Alerts about the hot muffler and exhaust area to prevent burns.
Informs about chemicals in exhaust known to cause cancer and birth defects.
Emphasizes reading the manual for safe operation to prevent injury.
Explanation of safety alert symbols (DANGER, WARNING, CAUTION) and their meanings.
Guidance on physical condition and essential safety gear for operation.
Safety rules for using attachments, guards, and checking for damage.
Instructions for clearing the work area and maintaining a firm grip.
Guidelines on approved gasoline, oil, and safe fuel handling procedures.
Steps for correctly mixing gasoline and two-stroke oil.
Instructions for using the unit in vacuum and shredding mode.
A guide to diagnosing and resolving common engine-related issues.
Lists conditions and damages not covered by the ECHO warranty.
General