9
SHRED 'N' VAC
®
OPERATOR'S MANUAL
ASSEMBLY
WARNING DANGER
Never perform maintenance or assembly procedures with engine
running, or serious personal injury may result.
BLOWER APPLICATION
Install Blower Pipes
1. Align grooves in straight pipe with pegs on blower housing and
slide pipe onto housing.
2. Turn straight pipe clockwise to lock into place.
3. Align grooves in fan head nozzle with pegs on straight pipe and
slide fan head nozzle onto straight pipe.
4. Turn fan head nozzle clockwise to lock into place.
VACUUM/SHREDDING APPLICATION
Install Vacuum Tube and Bag Assembly
1. Turn knob (A) counter clockwise until hinged housing cover is
free to open for vacuum tube installation.
2. While holding housing cover open. Install vacuum tube into
blower housing with bevel end facing downward and secure
vacuum tube with clamp (B). Clamp fits under slotted guides (C).
NOTE
Engine will not start/operate unless safety interlock switch (D) is
activated by the vacuum tube.
3. Remove blower pipe assembly from unit.
A
B
C
D
To Next Page
Loading...
Need help?
General