15
POWER BLOWER
OPERATOR'S MANUAL
AIR FILTER
Level 1.
Tools required: 25-50 mm (1-2 in.) Cleaning brush.
Parts required: 90008 REPOWER
TM
Air and Filter Kit
NOTE
Clean daily.
1. Close choke (Cold Start Position [
]). This prevents dirt from
entering the carburetor throat when the air filter is removed. Brush
accumulated dirt from the air filter area.
2. Remove the air filter cover. Lightly brush debris from filter. If filter
is fuel soaked, deformed, or very dirty, replace it.
3. If filter can be reused, be certain it:
• fits tightly in the air filter cavity.
• is installed with the original side out.
FUEL FILTER
Level 1.
Tools required: 200-250 mm (8-10 in.) length of wire with one end bent
into a hook, Clean rag, funnel, and an approved fuel
container.
Parts required: 90008 REPOWER
TM
Air and Filter Kit
WARNING DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
To Next Page
Loading...
Need help?
General
