Do you have a question about the Echo PB-413T and is the answer not in the manual?
Set throttle lever to Wide Open Throttle position.
Engage choke to Cold Start position and pump purge bulb until fuel is visible.
Pull starter handle until engine fires, then move choke to Run position.
Move throttle to idle position and allow engine to warm up before use.
Set throttle to idle detent position and switch to run.
Pump purge bulb and pull starter handle without choke.
Move throttle to idle, then to stop position.
Set throttle lever to Wide Open Throttle position.
Engage choke to Cold Start position and pump purge bulb until fuel is visible.
Pull starter handle until engine fires, then move choke to Run position.
Move throttle to idle position and allow engine to warm up before use.
Set throttle to idle detent position and switch to run.
Pump purge bulb and pull starter handle without choke.
Move throttle to idle, then to stop position.












Loading...