Echo SC-3013 User Manual

22 3 INCH CHIPPER/SHREDDER
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES REMEDY
Cannot engage belt
Improper belt installation, belt not under belt
guide
Install belt properly, install belt under belt
guide
Improper belt tension
$GMXVWEHOWWHQVLRQ5HSODFHEHOWRUEHOW
tension spring if needed
Excessive belt wear
Not using correct belt
Contact your nearest authorized dealer to
order the correct belt for your chipper
Pulley(s) damaged or worn Replace pulley(s)
Pulley(s) not in alignment
Align pulley(s) to within 1/16" with straight
edge
Belt(s) tension too loose Replace belt or belt tension spring
Hard to feed chipper,
requires excessive
power to chip
Dull chipper blades Flip, sharpen, or replace
Obstructed discharge
8VHEUDQFKRUVLPLODUREMHFWWRFOHDU
discharge tube
Improper blade clearance
Set blade/anvil clearance to recommended
distance
Excessive vibration
while running
Dull chipper blades Flip, sharpen, or replace
Drive system vibration
Check drive belts, bearings, and pulleys for
bad or worn areas. Check for dull chipper
blades.
Rotor out of balance
Inspect rotor for damaged or missing
chipper blades, replace if needed
Chipper blade to anvil clearance is incorrect
Set blade/anvil clearance to recommended
distance

Echo SC-3013 Specifications

General

Brand	Echo
Model	SC-3013
Category	Paper Shredder
Language	English