To Next PageTo Next Page
Need help?Do you have a question about the Echo SRM-260 - PARTS CATALOG SERIAL NUMBERS 04001001-04999999 and is the answer not in the manual?
The main engine casing.
Protective cover for the muffler.
Container for holding fuel.
Filters debris from the fuel.
Allows air into the fuel tank.
Lines for fuel delivery and return.
Housing for the cooling fan and clutch.
Part of the centrifugal clutch mechanism.
Engaging components of the clutch.
Spring that operates the clutch shoes.
Complete unit for starting the engine.
Component that holds the starter rope.
Rope used to manually start the engine.
Spring mechanism for retracting the starter rope.
Filters incoming air to the engine.
Housing for the air filter element.
Regulates fuel-air mixture for combustion.
Complete fuel and air metering unit.
Main housing of the carburetor.
Controls fuel flow into the carburetor.
Regulates fuel flow into the float bowl.
Component that operates the inlet needle.
Set of seals and diaphragms for carburetor maintenance.
Protective shield for the exhaust system.
Reduces engine noise.
Screen within the muffler assembly.
Seals the muffler to the exhaust port.
Generates high voltage for the spark plug.
Rotating mass that drives ignition timing.
Ignites the fuel-air mixture.
Alternative spark plug for specific models.
Connects ignition system to engine ground.
Core engine components including cylinder and piston.
The chamber where combustion occurs.
Includes piston, rings, and pin.
Converts piston motion to rotational force.
Housing for the crankshaft and bearings.
Protective plastic guard for the unit.
The main protective shield component.
Component for cutting trimmer line.
Enclosure for the gear reduction mechanism.
Internal gears for power transmission.
Shaft transmitting power to the cutting head.
The outer casing of the gear assembly.
The primary shaft connecting components.
Transmits rotational power to the cutting head.
The main grip for operating the trimmer.
The ergonomic grip on the handle.
Bracket for mounting the upper handle.
Bracket for mounting the lower handle.
Assembly for throttle control and grip.
Operates the engine throttle.
Connects trigger to carburetor.
Controls engine power.
Grip for the control handle.
Brand identification logo.
Identifies the trimmer model.
Identifies the trimmer model variant.
Identifies the trimmer model variant.
Identifies the trimmer model variant.
Identifies the trimmer model variant.
Warning about hot surfaces.
Seal for the crankcase.
Seal for the intake manifold.
Additional seal for the intake manifold.
Seal between cylinder and crankcase.
Seal for the exhaust system connection.
Multi-purpose tool for assembly and maintenance.
Tool for tightening or loosening nuts and bolts.
Tool used to secure rotating parts.
Wrench for hexagonal fasteners.
Bar with hexagonal ends for specific fittings.
L-shaped tool for hexagonal sockets.
Tool for Torx (star-shaped) fasteners.
Tool for driving screws.
Tool for tightening drill chucks.
General