EasyManua.ls Logo

Echo SRM - 340 - User Manual

Echo SRM - 340
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Grass Trimmer/Brush Cutter
Operator's Manual
MODEL, SRM - 340
Serial Number 03001001 - 03999999
WARNING DANGER
Read rules for safe operation and instructions carefully. ECHO provides an Operator's
Manual and a Safety Manual. Both must be read and understood for proper and safe
operation.
WARNING
The engine exhaust from this
product contains chemicals known
to the State of California to cause
cancer, birth defects or other
reproductive harm.
X7502126800
X750003660
01/03

Questions and Answers

  • S
    Sara CombsJul 29, 2025
    Why is my Echo SRM - 340 engine cranking but hard to start or not starting at all?
    • R
      Richard KingJul 29, 2025
      If your Echo Trimmer's engine is cranking but having trouble starting, it could be due to several reasons. The fuel strainer or fuel line might be clogged, or there could be an issue with the carburetor. Try cleaning or replacing the fuel strainer or fuel line. Also, the fuel mixture might be too rich; in that case, open the choke, clean or replace the air filter, or adjust the carburetor. If there's no spark, ensure the switch is turned ON. Finally, check the spark plug; if the spark gap is incorrect, adjust it to .65mm (0.026 in.), or clean or replace the plug if it's covered with carbon or fouled with fuel.
  • Q
    qgoodmanAug 12, 2025
    What to do if my Echo Trimmer engine runs but dies or won't accelerate properly?
    • C
      cherylacostaAug 12, 2025
      If your Echo Trimmer engine runs but dies or doesn't accelerate properly, several factors could be the cause. Contaminants or residues in the fuel may be the issue; try replacing the fuel. The air filter might be affected by extended operation in dirty or dusty locations, so try cleaning it. Also, the carburetor jet and fuel filter might have normal wear and require cleaning or replacement. Finally, improper carburetor adjustment may be the cause; try adjusting it.

Summary

Introduction

The Operators Manual

The Safety Manual

Manual Safety Symbols and Important Information

Safety

Decals

Locating and understanding safety decals on the unit.

Shaft Decal

International Symbols

Safety Instructions

Personal Condition and Safety Equipment

Advice on operator's physical state and required gear.

Extended Operation;Extreme Conditions

Precautions for prolonged use and adverse weather.

Repetitive Stress Injuries

Equipment

Safe Operation

Emission Control

Description

Package Contents

List of all items included in the product package.

Model SRM-340 Parts

Model SRM-340 Part Descriptions

Specifications

Assembly

Drive Shaft;Power Head

Steps for connecting the drive shaft to the power head.

Plastic Shield Installation

Guide for attaching the debris shield for nylon line use.

Nylon Head Installation

Blade Operation

Install Metal Shield

Steps for installing the protective shield required for blade use.

Install Blade

Front Handle;Barrier Bar Installation and Adjustment

Throttle Linkage and Ignition Leads

Balance and Adjust Unit

Pre-Operation

Operation with Blades

Specific requirements and safety for blade usage.

Choosing the Correct Blade

Guidance on selecting the appropriate blade for the cutting task.

Fuel

Fuel Requirements

Specifications for gasoline and two-stroke oil mixture.

Mixing Instructions

Step-by-step guide for preparing the fuel mixture.

Handling Fuel

Safety precautions for mixing, storing, and using fuel.

After Refueling

Procedures to follow immediately after refueling the unit.

After Use

Guidelines for fuel management after the equipment is used.

Storage

Recommendations for storing the unit, especially for long periods.

Operation

Starting Cold Engine

Step-by-step instructions for starting a cold engine.

Starting Warm Engine

Steps for starting the engine when it is already warm.

Stopping Engine

Procedures for safely shutting off the engine.

Maintenance

Skill Levels

Grading of maintenance tasks based on required expertise.

Maintenance Intervals

Schedule of recommended maintenance procedures and frequency.

Air Filter

Fuel Filter

Spark Plug

Cooling Systems Cleaning

Exhaust System

Spark Arrestor Screen

Instructions for cleaning or replacing the spark arrestor screen.

Carburetor Adjustment

Lubrication

Gear Housing

Instructions for checking and adding grease to the gear housing.

Nylon Line Replacement

Procedure for replacing the nylon trimmer line.

Sharpening Metal Blades

Sharpening 8-Tooth Blades

Specific steps for sharpening the 8-tooth blade.

Troubleshooting

Engine Problem Troubleshooting Chart

Detailed guide for identifying and fixing engine issues.

Storage

Long Term Storage (over 30 days)

Specific steps for preparing the unit for extended storage.

Servicing Information

Parts

Information on obtaining genuine ECHO parts.

Service

Guidance on authorized service centers and warranty repairs.

ECHO Consumer Product Support

Contact details for customer assistance and inquiries.

Warranty Registration

Information on registering the product for warranty purposes.

Additional or Replacement Manuals

How to obtain extra copies of manuals.

Echo SRM - 340 Specifications

General IconGeneral
Engine Type2-stroke
Power Output1.3 kW
Shaft TypeStraight
Cutting Width17 inches (43 cm)
Fuel Tank Capacity0.84 L
Warranty5 years consumer, 2 years commercial

Related product manuals