Pull up the locking button on the connector, push in the tube (either a tube already fitted to the hedge
trimmer attachment or the optional extra extension tube), release the locking button, align the hole in
the pole with the hole in the connector of power unit until you hear a click from the connector.Tighten
the knob.(See photos as below)
To disconnect:
Loosen the tighten knob, pull the locking button on the connector outwards, then pull out the
attachment pole before releasing the locking button.
3) Fitting the belt :
Clip to the power unit and adjust for length and comfort.
(see photos as below)
To Next Page
Loading...
