Eclipse 1000 - Page 22

WARNING Secure the ECLIPSE and the DC Power Supply in your vehicle and
make sure the air inlet and exhaust airflow are not blocked. This may
impact performance.
WARNING DO NOT leave the ECLIPSE or DC Power Supply plugged into the
vehicle without the engine running or attempt to start the vehicle
while the DC Power Supply is connected to the vehicle. This may
drain the vehicle’s battery.
A buzzer in the DC Power Supply is intended to warn user when low vehicle power is
present. Immediately disconnect the DC Power Supply from the vehicle for low voltage
alarm conditions.
WARNING If the vehicle power source (vehicle accessory connector) drops below
11.5 Volts (brownout) the ECLIPSE will revert to Power Cartridge
operation (if present). The External Power Present Indicator may remain on.
TYPICAL FLOW RATES AVAILABLE AT EACH FUSE SETTING
10 AMP 15 AMP
Setting Continuous Pulse Continuous Pulse
0.5 Yes – Yes –
1.0 Yes Yes Yes Yes
1.5
Y
es Yes Ye s Ye s
2.0
Y
es
Ye s Ye s Ye s
2.5
N
O
Y
es
Y
es Yes
3.0 NO Yes Yes Yes
3.5 – Yes – Yes
4.0
–
Ye s – Ye s
4.5 – Yes – Yes
5.0
–
Y
es – Yes
5.5 – Yes – Yes
6.0 – Yes – Yes
Actual performance may vary dependent upon usage conditions and vehicle.
Operating Instructions (continued)
20
|
ECLIPSE
TM
Model 1000 User Manual
StockCheck.com