Your scooter requires a minimal amount of care and maintenance. If you do not feel confident in
your ability to perform the maintenance listed below, you may schedule inspection and maintenance
at your authorized dealer. The following areas require periodic inspection and / or care
and maintenance.
Tire Pressure
• If equipped with pneumatic tires, always maintain the psi/bar/kPa air pressure indicated on
each tire.
• It is important that the psi/bar/kPa air pressure indicated on each tire be maintained in
pneumatic tires at all times. Do not underinflate or overinflate your tires.
• Low pressure may result in loss of control, and overinflated tires may burst. Failure to
maintain the psi/bar/kPa air pressure indicated on pneumatic tires at all times may result in
tire and/or wheel failure.
• Regularly inspect your scooter's tires for signs of wear.
Motor Brakes
If the motor brakes are functioning correctly, you will not be able to push your scooter when it is
switched off or switched on with the speed control throttle in the neutral position.
If your scooter can be pushed, the motor brake(s) may be faulty. Please do not use the scooter
and contact your local dealer immediately.
SAFETY NOTE: For your own safety, we recommend that you check the function of your scooter
brakes prior to using.
Exterior Surfaces
• Bumpers, tires, and trim can benefit from an occasional cleaning. Using a clothe, lightly wash
with mild soap and water.
• Do not use rubber or vinyl conditioner on the scooter's Vinyl seat or tire tread, as this
may cause them to become slippery.
CAUTION: Do not directly spray water at your scooter. Water could be forced into the
electronics and cause permanent damage.
Cleaning and Disinfection
• Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal parts of your
scooter. Avoid using products that may scratch the surface of your scooter.
• If necessary, clean your product with an approved disinfectant. Make sure the disinfectant is safe
for use on your product before application.
• Follow all safety instructions for the proper use of the disinfectant and cleaning agent before
applying it to your product. Failure to comply may result in skin irritation or premature
deterioration of upholstery and/or scooter finishes.
Battery Terminal Connections
• Make certain that the terminal connections remain tight and un-corroded.
• The batteries must sit flat in the battery wells.
To Next Page
Loading...