EasyManua.ls Logo

Ecobike Basic Black - Page 17

Ecobike Basic Black
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
cost of such inspection shall be
paid by the Beneficiary. Failure to
inspect the Product results in the
loss of the Warranty for mechan-
ical components. The inspection
should be confirmed by an ap-
propriate entry in the Warranty
Card with a signature and stamp
of the service point.
5. The Warranty does not cover the
following:
components that are subject to
wear through use: tires, brake
pads, brake cables, saddle, han-
dlebars grips, wheel centring,
pedals, expected wear of the
chain, sprockets, and expect-
ed wear of battery (determined
based on an expert opinion).
components that have been
damaged by impact or mechan-
ical damage, including a broken
derailleur dropout, paint chipped
as a result of rough handling of
the Product, damaged crank
threads, or burnt-out lightbulbs.
elements damaged through mis-
alignments, such as steering and
hub cones
6. The Beneficiary loses their right
to exercise the Warranty in the
following cases:
using the Product contrary to its
intended purpose. This includes
bicycle acrobatics and extreme
sports
damaging the Product mechan-
ically
storing the Product in inappro-
priate way
failing to regularly perform the
required bike maintenance, in-
cluding lubrication of mechanical
parts of the bike
attempting to protect the Prod-
uct against damage inappropri-
ately or using inappropriate ma-
terials.
using the Product in ways con-
flicting with the users manual.
damaging the Product in an un-
fortunate event (such as a traffic
accident).
failing to perform the obligatory
inspection of the Product at the
start of its life (point 4 of the
Warrant Conditions).
attempting to repair the bicycle
themselves or allowing unautho-
rised people to perform repairs
or maintenance.
7. The Beneficiary is charged with
the following responsibilities:
ensure the working conditions of
the bike and that the necessary
alignments are performed when
necessary.
check for play in the bike’s fas-
teners and remove that play
when necessary.
check the tire pressure and pump
the tires when necessary.
to keep the Product clean, in par-
ticular the chain, sprockets and
other moving parts.
8. Regarding the battery, the fol-
lowing instructions should be fol-
lowed:
After the first use and after the
battery has not been in use for
a considerable amount of time,
it should be drained completely
and recharged to the maximum
capacity.
A drained battery should be re-
charged within 24 hours.
In case the Product will not be
used for a considerable amount
of time, the battery should be
fully charged, removed, and then
stored.
If the Product is not regularly
used, charge the battery once a
month.
9. Product defects or damage en-
countered during the Warran-
ty period should be reported to

Related product manuals