Picture 1 – Put front wheel into the fork.
Picture 2 – insert the "pin" through the wheel,
tighten the nut on the left side so that the
quick-release closure is tightened with the
appropriate resistance.
1. Put the handlebar in the most
comfortable position for you and tighten
all screws according to the picture below.
2. The handlebar should be mounted so
that there are no clearances.
1. Loosen the quick-release nut on the
bicycle frame and insert the saddle post.
2. Tighten the clamps of the seatpost clamp
in such a way that the quick coupling
clamps with the appropriate resistance.
7.5 PEDALS ASSEMBLY
➢ Tighten the pedal with the letter "R" on the right side clockwise,
➢ Tighten the pedal with the letter "L" on the left hand side clockwise.
8. GREASE
Lubricated elements must be clean. Before lubricating the bearing, after dismantling it
should be thoroughly cleaned and wiped dry with a clean cloth. Then apply a quantity of
grease to the balls of the balls to fill all the gaps.
Excess grease adversely affects the work of the ball bearing - its heating occurs. We
lubricate ball bearings with a grease at the following time intervals:
✓ Every 6 months, the bearings of the front wheel hub of the rear hub bearing.
✓ Every 12 months the steering bearings.
We lubricate the following moving parts of the bicycle every six months:
✓ brake lever axles,
✓ brake lining axles,
✓ brakes,
✓ gears,
✓ moving parts of gears
To Next Page
Loading...
