Make sure that the Input Cable, Fuse Cable, and Output Cable are connected firmly as loose
connections can cause cable melting.
Compatibility
Vehicle Starter Battery or RV House Battery
Please make sure the vehicle starter battery or RV house battery is undamaged and rechargeable.
The battery's nominal voltage should be 12V or 24V.
Are there any requirements for car models?
The overall voltage of some older or special car models is relatively low and the charger may fail to
work as a result. In this case, use the EcoFlow app to adjust the start voltage of the charger.
Portable Power Station or Extra Battery
The 800W Alternator Charger is connected to the extra battery port (XT150) of the EcoFlow
portable power station or extra battery via the XT150 Output Cable. Please make sure your EcoFlow
portable power station or extra battery has a port of this kind.
Environmental Requirements
To make sure the charger can operate normally, the location where the charger is placed or installed
should meet the following requirements:
1. Be near to the portable power station or extra battery as the Output Cable is only 1m long
and its length cannot be extended.
2. Has adequate connection space around the ports.
3. Be dry and tidy with a moderate temperature and away from heat sources.
4. Be away from flammable substances as the charger produces heat when it’s in use.
5. Be well-ventilated and not covered by blankets or anything that will hinder ventilation.
6. Be away from children and pets.
Install Your Charger (Optional)
For smooth rides, you can place the charger on the power station. For bumpy rides, it’s recommended
to install the charger securely.
To Next Page
Loading...
