ecofort ecodry CaveMaster - Troubleshooting Guide

ENGLISH
67
Troubleshooting Guide
PROBLEM SOLUTION
The dehumidier does
not switch on
• Make sure that the mains lead is properly plugged in and
that there is power in the wall socket.
• The water tank is full or incorrectly tted.
• The set humidity level has been reached.
• Power plug or cord damaged.
The humidity is not
reducing
• The dehumidier has not been used long enough.
• Make sure that all doors and windows are closed.
• The ambient temperature is too low.
• The surrounding humidity level is too low.
• The air lter on the back of the unit is dirty.
• Exceeded recommended room coverage area.
• The ambient humidity level is lower than the desired
humidity level set.
Unusual noises • The dehumidier is tilted or standing on an uneven
surface.
• Make sure that the air lter is clean.
• Loose or foreign particles inside the unit.
• Sound of owing refrigerant.
Water in tank overows • Water tank may be damaged.
• Float for water auto-sensor is not in place or blocked.
• Internal drainage passage is blocked or obstructed.
Display LO
Display HI
Ambient humidity is lower than 30% - the display will
return to showing ambient humidity, when it is above
30%.
Ambient humidity is higher than 90% - the display will
return to showing ambient humidity, when it is below
90%.