What to do if ECOGENICA EG-260FR stops working after 3 occurrences within 1 hour?
If your ECOGENICA Heat Pump stops working after three occurrences within one hour, power it on again. This will resume the re-detection process.
What to do if ECOGENICA Heat Pump is noisy?
If your ECOGENICA Heat Pump is producing excessive noise, consider adding vibration-absorbing rubber to the pipe fittings. Also, adjust the distance between the components and pipes to minimize vibration and noise.
What to do if user temperature output is low on ECOGENICA EG-260FR?
If the user temperature output is low on your ECOGENICA Heat Pump, adjust the mixing valve to control the ratio of hot water and cold water for the desired temperature.
What to do if there is water shortage and the pump does not work in ECOGENICA EG-260FR Heat Pump?
If you're experiencing a water shortage and the pump isn't working in your ECOGENICA Heat Pump, check the amount of water available. Also, verify whether the pump is functioning correctly.
What to do if the filter is blocked in ECOGENICA Heat Pump?
If the filter in your ECOGENICA Heat Pump is blocked, activate the forced defrosting function and reverse the flush for one minute.
What to do if water temperature is too low in ECOGENICA EG-260FR?
Make sure the water volume of the water tank of your ECOGENICA Heat Pump. The machine will automatically detect and return to normal.
Critical warnings and cautions for installation, operation, and maintenance to prevent injury or damage.
Important notices regarding installation, maintenance, and hot water safety precautions.
Instructions for connecting water inlet, outlet, and PTR valve pipes.
Guidelines for electrical installation, including power supply, wiring rules, and safety.
List of fault codes, their description, heat pump status, and notes for diagnosis.
Common problems, their reasons, solutions, and phenomena for quick resolution.
Comprehensive installation instructions including piping, system requirements, and electrical connections.
General| Refrigerant | R410A |
|---|---|
| Heating Capacity | 26 kW |
| Cooling Capacity | 24 kW |
| Type | Air to Water |
| Power Supply | 380-415V/50Hz/3Ph |
To Next Page
