3.7 Standard installation
The standard installation is the command, which connects a washing program to the outlets of the
unit. The standard installation is pre-programmed by the supplier and should only be changed in
special cases and under expert guidance.
The selection decides the number of valves connected to the program and whether the valves are to
be used for rinsing, air, flushing, spray and foam lay out.
OK
Warning!
All existing programs
will be erased
Installation number is
changed using the
navigation buttons.
Confirm change by OK.
ow wait until the
change is active and the
resent installation in the
top line is changed.
31
To Next Page
Loading...
