To Next PageTo Next Page
Need help?Do you have a question about the EcoNet P16AZ24A and is the answer not in the manual?
Essential safety guidelines for installation, operation, and maintenance, including electrical hazards and warnings.
Details about the unit, installation manual, audit testing, quality installation, and system sizing.
Importance of proper unit matching, checking received product, and compressor break-in procedures.
Explanation of model numbers and tables for electrical and physical unit data.
Lists necessary tools and specifications for R-410A refrigerant installation.
Guidelines for choosing an installation location, required clearances, and operational issues.
Instructions for mounting units on ground, frames, elevated platforms, and tie-down methods.
Procedures for selecting refrigerant line sizes, considering length, fittings, and capacity losses.
Detailed steps for installing tubing, including connections, brazing, and insulation.
Procedures for performing initial leak tests and evacuating the system to remove air and moisture.
Wiring instructions for EcoNet™ and conventional thermostats, including power wiring.
Essential instructions for properly grounding the unit for safety.
Steps for powering up the system and verifying communication between components.
Configuring the EcoNet™ Control Center for system start-up and charging mode.
Procedures for enabling charging mode via EcoNet™ or conventional thermostat.
Ensuring correct indoor airflow is critical for system performance and charge accuracy.
Methods for charging by weight, pressure, and subcooling to ensure optimal performance.
Final tasks after refrigerant charging, including reconnecting components and exiting modes.
Operation during cooling, on-demand dehumidification, and low ambient cooling conditions.
Operation in heating, supplemental heat, dual fuel, and demand defrost sequences.
Details on the Variable Speed Outdoor Control and Power Inverter functions and features.
Descriptions of protections like high/low pressure, overcurrent, sensor failures, and lock-out modes.
List of EcoNet fault codes and recommended actions for system faults.
Procedures and charts for testing system transducers and temperature sensors for accuracy.
A table listing common system symptoms, possible causes, and remedies.
Detailed charts for diagnosing specific issues like compressor overheating, electrical faults, and EXV problems.
Concise tables summarizing common problems and indicators in cooling and heating modes.
Guidelines for cleaning coils, cabinets, motor lubrication, and replacement parts.
Schematic and wiring diagrams, component codes, and wire color codes.
Detailed steps for performing performance audit tests on the system.
General| Cooling Capacity | 24, 000 BTU/h |
|---|---|
| SEER | 16 |
| HSPF | 9.0 |
| Heating Capacity | 24, 000 BTU/h |
| Voltage | 208/230V |
| Phase | 1 |
| Refrigerant | R-410A |
