ECOTRIKES ET4 - Assembling The EcoTrikes Unit; Initial Assembly Steps

8
A
A
s
s
s
s
e
e
m
m
b
b
l
l
i
i
n
n
g
g
T
T
h
h
e
e
E
E
c
c
o
o
T
T
r
r
i
i
k
k
e
e
s
s
U
U
n
n
i
i
t
t
EcoTrikes
1. Unpack the EcoTrikes scooter carefully so
that you do not misplace any of the parts.
2. Place the EcoTrikes unit on a flat, level
surface. Block the front up 3.5''. This will
make the next step easier
3. Remove the bolts and nuts from the
connecting tube clamp (B). Place the
connecting tube into the top opening (A).
After aligning the holes, place the two bolts
through the connecting tube and neck
assembly. Twist the bolts, do not hammer
them through. Tighten these two bolts with the
nuts provided.