31
Using BIOS
TM2 Bus VID (0.8375V)
This item represents the voltage of the throttled performance state that
will be initiated when the on-die sensor goes from not hot to hot.
Limit CPUID MaxVal (Disabled)
This item can support Prescott CPUs for old OS. Users please note that
under NT 4.0, it must be set “Enabled”, while under WinXP, it must be set
“Disabled”.
Execute Disable Bit (Disabled)
This item is a security feature that helps you protect your CPU and operat-
ing system against malicious software executing code. This item is available
when CPU supports the feature.
Hard Disk Boot Priority (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
CPU L1&L2 Cache (Enabled)
All processors that can be installed in this mainboard use internal level 1 (L1) and external
level 2 (L2) cache memory to improve performance. Leave this item at the default value
for better performance.
CPU L3 Cache (Enabled)
This item is only available when processors support L3. Some high-end processors support
L3. If the CPU do support L3, you may set this item to enable or disable. Leave this item
at the default value for better performance.
Hyper-Threading Technology (Enabled)
This item is only available when the chipset supports Hyper-Threading and you are
using a Hyper-Threading CPU.
Quick Power On Self Test (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up faster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
First/Second/Third Boot Device (Floppy/Hard Disk/CDROM)
Use these three items to select the priority and order of the devices that your system
searches for an operating system at start-up time.
Press <Esc> to return to the Advanced Chipset Features page.
: Move PU/PD+/-/:Change Priority F10:Save ESC:Exit
1. Pri.Master:
2. Pri.Slave:
3. Sec. Master:
4. Sec. Slave:
5. USBHDD0:
6. USBHDD1:
7. USBHDD2:
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Hard Disk Boot Priority
Use < > or < >
to select a device, then
press <+> to move it
up, or <-> to move it
down the list. Press
<ESC> to exit this
To Next Page
Loading...
Need help?
General
